Honda 08B23-S0X-100 Installation Instructions Manual page 12

Installing the FM Modulator
43. Turn over the floor carpet. Plug the i -VES
harness 8-pin connector into the FM modulator.
ADHESIVE
BACKING
FM MODULATOR
44. Using isopropyl alcohol on a shop towel,
thoroughly clean the area where the FM modulator
will attach. Remove the adhesive backing from the
cushion on the FM modulator, and attach the FM
modulator to the SRS unit.
45. Route the FM modulator antenna leads to the
audio unit opening, and secure the FM modulator
antenna lead to the vehicle harness with one wire
tie.
FM MODULATOR
ANTENNA LEAD
12 of 15
i -VES
SRS HARNESS
UNIT 8-PIN
CONNECTOR
Turn over the
floor carpet.
i -VES
HARNESS
VEHICLE
HARNESS
i -VES
HARNESS
WIRE
TIE
FM
MODULATOR
46. Plug the vehicle antenna lead into the FM
modulator antenna lead.
FM MODULATOR
ANTENNA LEAD
Installing the DVD Player
If you're installing the DVD player into the beverage
holder opening, continue with step 46, otherwise; go to
step 51.
46. From the back of the DVD player, slide the bezel
onto the DVD player.
5 x 12 mm
WASHER-
SCREW
5 x 12 mm
WASHER-
SCREW
BEZEL
47. Attach the DVD player bracket to the DVD player,
and install the DVD player bracket with bezel to
the player using the five 5 x 12 mm washer-
screws.
AII 26017 (0308)
VEHICLE ANTENNA LEAD
DVD PLAYER
BRACKET
BEZEL
DVD PLAYER
BRACKET
© 2003 American Honda Motor Co., Inc - All Rights Reserved.
5 x 12 mm
WASHER-
SCREW
5 x 12 mm
WASHER-
SCREW
5 x 12 mm
WASHER-
SCREW