ENGLISH (Original instructions) SPECIFICATIONS Model: JV102D Length of stroke 23 mm Strokes per minute 800 - 3,000 min Blade type B type Max. cutting capacities Wood 90 mm Mild steel 10 mm Aluminum 20 mm Overall length 237 mm Rated voltage D.C.
Check for the proper clearance beyond the NOTE: The declared vibration total value(s) has been workpiece before cutting so that the blade will measured in accordance with a standard test method not strike the floor, workbench, etc. and may be used for comparing one tool with another. Hold the tool firmly. NOTE: The declared vibration total value(s) may also Make sure the blade is not contacting the be used in a preliminary assessment of exposure.
If you can see the red indicator on the have been altered, may result in the battery bursting upper side of the button, it is not locked completely. causing fires, personal injury and damage. It will CAUTION: also void the Makita warranty for the Makita tool and Always install the battery cartridge charger. fully until the red indicator cannot be seen. If not, it may accidentally fall out of the tool, causing injury to Tips for maintaining maximum you or someone around you.
Indicating the remaining battery NOTE: If the tool is left for 10 seconds without any operation in the standby mode, the tool automatically capacity turns off and the lamp goes off. Only for battery cartridges with the indicator NOTE: You can also stop and turn off the tool by ► Fig.2: 1. Indicator lamps 2. Check button pressing the lock/unlock button while the tool is operating. Press the check button on the battery cartridge to indi- cate the remaining battery capacity. The indicator lamps Lighting up the front lamp light up for a few seconds.
Disabling the soft no-load rotation CAUTION: If the lever does not move to the fixed function position, the blade is not installed completely. Do not press the lever by hand to the fixed position. It may To disable the soft no-load rotation function, follow the damage the tool. steps below. To remove the jig saw blade, push the lever forward as Make sure that the tool is turned off. far as it will go. This allows the blade to be released. Set the speed adjusting dial to "1". ► Fig.8: 1. Jig saw blade holder 2. Jig saw blade Press the lock/unlock button to turn on the tool. NOTE: Occasionally lubricate the roller. Set the speed adjusting dial to "5" by turning it, and then set it to "1" by turn it back. Hex wrench storage The lamp blinks twice to indicate that the soft no-load rotation function is disabled. To enable this function ► Fig.9: 1. Hook 2. Hex wrench again, perform the same procedure again.
Page 12
Dust extraction Anti-splintering device Optional accessory Optional accessory Clean cutting operations can be performed by connect- CAUTION: ing this tool to a Makita vacuum cleaner. The anti-splintering device cannot be used when making bevel cuts. Installing or removing the dust cover ► Fig.27: 1. Base 2. Anti-splintering device Install the dust cover as shown in the figure.
Centers, always using Makita replacement parts. OPTIONAL ACCESSORIES CAUTION: These accessories or attachments are recommended for use with your Makita tool specified in this manual. The use of any other accessories or attachments might present a risk of injury to persons. Only use accessory or attachment for its stated purpose.