Table of Contents
Advertisement
AEG
How to use :
nvoStatus is set only when a request status is asked .
ACTION
NvoStatus
object_id
The node object
0
is disable.
3.5 Different configurations
This product supports 3 different configuration processes on the network :
-automatic installation : nothing has to be done at installation ; all the Actuator interfaces belong
to the same group have the same behavior regarding the sensors of the installation . This
automatic installation is implemented when the product leaves the production line ; as soon as
another configuration process is used , the automatic installation cannot be used anymore
unless a specific software is done on the device itself.
-PC configuration by the means of an appropriate software.
-intuitive installation : it is an installation configuration used in the SOMFY LonWorks products to
configure an installation of sensors and actuators on the network .
This configuration consists in creating groups of actuators.
All the actuators of the group have the same behaviour regarding the sensor controlling the group
.
The intuitive configuration requests for all the products one button and one LED ; those are ID
button and the ID LED .
The process of creating a group , at first installation or for a modification , is as follows :
• Press the ID button of a sensor during approx. 5'' until its ID LED flashes ; wait until it stops
flashing and turns on continuously.
• Press the ID button of an actuator ( ex : BIU-LT interface , BUI-6AC interface , BIU-ILT
interface...) whose will be controlled by the sensor . Its ID LED and the ID LED of the sensor
will flash during few seconds , then its ID LED will turn on as the ID LED of the sensor will turn
on again ; this means that the actuator is no longer control by the sensor .
• If an actuator is controlled by the sensor , its ID LED is turn on .The actuator will be no longer
control by the sensor , give a pulse on its ID button . Its ID LED of the sensor will flash during
few seconds , then its ID LED will turn off ; this means that the actuator is no longer control
by the sensor .
• When the group has been set ( or modified ) , a pulse on the ID button of the sensor ends the
process . All the ID LED will turn off .
Nota : the process is anyhow now ended when no ID LED is activated during 3 minutes
after the process has been initiated .
invalid_id
0
Table 2 : How to use nvoStatus
Functional description Sun
ref FD 157990 Version 1.0
invalid_request
disabled
0
0
27/01/03
13/15
Advertisement
Table of Contents
