Pre-Alarm; Fault - Honeywell NOTIFIER ID61 Operating Manual

ZONE FIRE
1 2 3 4
ZONE FAULT
DISABLE/TEST
FIRE
POWER SUPPLY FAULT
DISABLEMENT
TEST
FIRE CONTROL O/P: FAULT/ DISABLED
997-458-000-8, Issue 8
January 2010
ID61/62 Series Panel - Operating Manual
3.2

Pre-alarm

When one or more input devices signal to the panel a
reading higher than normal but not yet at the FIRE level,
this is a PRE-ALARM condition.

FAULT

Automatic panel actions
EARTH FAULT
a. Intermittent operation of the internal buzzer (one
SYSTEM FAULT
SOUNDER: FAULT/ DISABLED
PRE-ALARM
b. Operation of the appropriate ZONE FAULT/DISABLE/
c. Displays information on the LCD regarding the pre-
Status: FAULT
PRE-ALARM
d. Operation of any assigned outputs in response to a
Recommended operator actions:
1 Operate the MUTE buzzer pushbutton to silence the
2 Check condition of sensor indicated and check area
second ON, one second OFF).
TEST LED and yellow PRE-ALARM LED.
alarm condition.
01/02
general pre-alarm condition at the panel (refer to
Section 5.7 Control-by-Event Rules).
panel's internal buzzer.
for possible fire. If the cause cannot be determined
notify authorised servicing company.
8
14:55