Honeywell Viewguard DUAL AM FAI Mounting And Connection Instructions page 12

12
7.4 Cable entry, strain relief
3
B
3
C
3
D
Fig. 11
7.5 Fix housing base
4
4
2
Fig. 12
7.6 Backtamper
When installed in accordance with VdS systems class B and C, the backtamper must be used.
Please note, that the backtamper is not possible when mounting according to Fig. 9/3c.
Note: In state of delivery the backtamper is blocked.
Fig. 13/1
5
6
Fig. 13/2
3
A
3
A For s.m. wiring
3
B
3 3
+
B D For f.m. wiring
3
C
3
C For strain relief with cable strap
3
D For use with Adjustable joint
3
D
The method of attachment of the housing base depends on installation according to Fig. 9:
3
- 0° Vertical (Fig. 9/1)
Screw on position
- 3° Vertical (Fig. 9/2)
Screw on position
1
- 45° Horizontal to the left or right
- To the right:
- To the left:
- Corner mounting
5
Remove "Protective cover
Screw on position
3 Only fix the housing base on one side with 2 screws. When screwing down the back with 4 screws, it
may become taught and the front of the housing may no longer fit.
The mounting on adjustable and ball-and-socket joints is described in the respective
instructions.
Tappet build-in
1
3
Activation of backtamper:
1
1. Remove the tappet from the holder
4
2. Cut off the blocking pin .
1
3. Insert the tappet back into the holder
If the detector is mounted correctly to the wall, the pressure pin
cover contact.
If the detector is torn away, the pressure spring
triggered.
Mounting and Connection Instructions Viewguard DUAL / AM FAI
1
.
2
.
(Fig. 9/3)
Remove "Protective cover
3
Screw on 2 positions .
4
Screw on 2 positions .
(Fig. 9/4)
5
for back-tamper" (on the rear)
3 4
or .
Tappet removed
2
4
Pin
removed
Function with blocking pin
Function without blocking pin
5
. To do so, a small mechanical resistance must be overcome.
5
.
2
pushes the tappet outwards and the cover contact is
5
for back-tamper" (on the rear)
Fig. 13/1
1
Tappet for cover contact and backtamper
2
Pressure spring
3
Pressure pin
4
Blocking pin (for blocking the backtamper)
Fig. 13/2
5
Pin holder
6
Opening for pressure pin
4
: only cover contact (backtamper blocked)
4
: cover contact and backtamper
3
pushes the tappet inwards to activate the
3