Honeywell GENT VCS-PSU-N Installation

Installation
Replacement PSU PCB & Cover
(VCS-PSU-N)
These instructions cover how to install the replacement PSU
PCB assembly and cover (VCS-PSU-N) in to a Vigilon Compact
panel, either COMPACT-24 (non networkable) or
COMPACT-24-N (networkable) panel or Nano panel (NANO-24)
. The package contains:
1 - Replacement PSU PCB assembly
To replace the PSU in a Vigilon Compact panel
&
Isolate the mains power supply to the Vigilon Compact
panel.
Removal
Open the outer and inner doors of the panel.
a.
b. Disconnect the mains cable from the mains terminals
PSU PCB assembly and unplug the battery circuit cable
k
from connector .
c. Remove the two nuts and washers from the panel
for later use) and lift out the cover
d.
Disconnect the ribbon cable
Remove the two screws and washers that secure the PSU
e.
o
assembly (keep for later use) and lift out the PSU PCB
p r
assembly or from the clinching standoffs.
Replacement
a.
Fit the Replacement PSU PCB assembly
self clinching standoffs.
&
Ensure that the Replacement PSU PCB assembly is
secured using screws and washers at the two fixing points
b.
Reconnect the ribbon cable
PCB assembly and MCB assembly.
c.
Align the Replacement cover
panel side. Slide the cover down and secure it using the
l
nuts and washers
d.
Reconnect the mains cable to mains terminals
Replacement PSU PCB assembly.
e. Reconnect the battery circuit to connector
Replacement PSU PCB assembly .
Close the inner and outer doors of the panel.
f.
4188-905 issue 2_07/08_Replacement PSU
1 - Replacement Cover
Not used on Nano
panel
m q
or .
n
.
r
n
between Replacement PSU
q
with the two fixings on the
.
k
Vigilon Compact panel
WARNING
REMOVAL OF COVER
EXPOSES HIGH VOLTAGE
Inner door
MCB
assembly
j
at
l
(keep
on to the two
MCB
assembly
o
.
j
on the
on
by Honeywell
Back box
REMOVE ONLY
DURING COMMISSIONING
Existing PSU
New PSU
1