Safety Instructions - Honeywell Envitec MySignO Operating Manual

Oxygen measuring device MySign
1

Safety instructions

The system may only be used by operators with sufficient knowledge of said equipment and
this operating manual. The system must only be used for the purpose described.
Do not operate this system in explosive areas!
This system is not approved for use in explosive areas.
Please note the potential risks when dealing with flammable gases such as oxygen or
anaesthetic gases, for example.
Anaesthetic gases and oxygen gas mixtures are flammable at higher concentrations.
Portable and mobile HF communication devices can interfere with and disrupt electrical
medical devices.
The device must not be operated in connection with a defibrillator.
When using the system with patients, the system may not be connected to a computer by
the data cable.
Commissioning
Always note whether there is any damage to the system, sensor or spiral cable before starting
the system it up. Never use devices that are damaged!
Maintenance
The oxygen monitor must only be maintained and serviced by the hospital/retailer's technical
service personal or by EnviteC-Wismar GmbH staff.
Symbols used in this manual
Danger of death, serious injury or considerable material damage if the relevant
safety measures are not observed.
Important information about the product or a specific part of the manual which
should be read with particular attention.
Disposal
In accordance with Directive 2002/96/EC (WEEE), the manufacturer will accept
the return of the electrical and electronic device for proper disposal after
dismantling!
4
®
O
Doc no.: 065-07-1001825_MySignO_GB-0.pdf / 12.11