Honda 08E51-S84-100 Operating Instructions Manual page 11

Remote Control Code Programming
( D or@
Press the ' LOCK" or ' UNLOCK" button on
the re mote control transmirter.
o
Th e power door locks· cycle to indicate
programming mode .
The Slatus LED illuminates simu ltane­
ously for 1 second.
o
To terminate the programming mode at
th is point. either turn the ignition key to the
"OFF" position or leave the rem ole's
button untouched for over 10 se conds. To
program the remote, perform steps 2
thro ugh 12.
Press the "LOCK' button of each remote
(one at a line)
10
be stored in memmy.
o
The power door locks* cycle to confirm
each entry.
The Status LED illuminates simultane­
ously for 1 second.
o
A button on each remote control transmit­
ter to be programmed must be pressed.
Perform the programming step within 10
seconds for each remote or else the
programming mode will terminate .
Note:
Only 4 remotes can be stored in tile
system's memory .
* On vehicles equipped with power door locks .
11