Fixing The Support Brackets; Granite Worktops; Building In The Gas Hob - Miele KM 404 Installation Instructions Manual

Installation KM 404 / KM 405 / KM 406

Fixing the support brackets

^ Position the two support brackets
supplied a in the positions shown in
"Fitting the spacer bars and support
brackets" so that they are flush with
the top edge of the cut-out, and
secure with the 3.5 x 25 mm screws
supplied. 2 screws are needed to
secure each support bracket.
The thickness of the worktop will
determine which drilled hole is used.
Please note that height of the
support bracket for the KM 406 is
different to that for the KM 404 and
KM 405.
16

Granite worktops

On a granite worktop a hole must be
drilled d at the position indicated to
secure each support bracket.
^ Using a piece of strong, double-
sided adhesive tape position the
support brackets supplied a at the
positions indicated flush with the top
edge of the worktop and secure each
bracket with one screw in hole d as
shown.

Building in the gas hob

^ Lay the gas hob in the prepared
cut-out.
^ Draw the electricity connection cable
through the cut-out and connect.
^ Make the gas connection (see
chapter "gas connection").
^ Secure the gas hob from below
through the middle elongated hole b
in each support bracket using the
two screws supplied. Carefully adjust
the hob if necessary.