Warning And Safety Instructions; Building In - Miele KM 404 Installation Instructions Manual

Warning and Safety instructions

Building in

Fit wall units and the cooker hood
before fitting the appliance, to avoid
damaging it.
As a minimum 20 m
required where the appliance is
installed, and a door or window which
can be opened to the outside air.
The veneer or laminate coatings of
worktops (or adjacent kitchen
units) must be treated with 100 °C heat
resistant adhesive which will not
dissolve or distort.
The worktop upstand must be heat
resistant.
Ideally the hobs should be installed
with plenty of space on either side.
There may by a wall at the rear and a
wall or tall units at one side. On the
other side, however, no unit or divider
should stand higher than the hob.
Due to the heat radiated by the hob
and to allow cooking fumes to
dissipate it is essential that a
minimum safety distance a is
maintained between the worktop
cut-out and adjacent kitchen units,
e.g. a tall unit, as follows:
100 mm with KM 404 / KM 405
250 mm with KM 406
200 mm with KM 414 / KM 417
There must be a minimum safety
distance of 50 mm between the
appliance and a back wall.
4
3
space is
recommended
not recommended
not allowed