Fixing The Support Brackets; Granite Worktops; Building In The Gas Hob - Miele KM 404 Installation Instructions Manual

Installation KM 404 / KM 405 / 406

Fixing the support brackets

^ Position the two support brackets
supplied a in the positions shown in
"Fitting the spacer bars and support
brackets" so they are flush with the
top edge of the cut-out and secure
using the 3.5 x 25 mm screws
supplied. 2 screws are needed to
secure each support bracket.
The thickness of the worktop will
determine which drill hole is used.
Please note that height of the
support bracket for the KM 406 is
different to that for the KM 404 and
KM 405.
16

Granite worktops

On a granite worktop a hole must be
drilled d at the position indicated to
secure each support bracket.
^ Using a piece of strong, double-
sided adhesive tape position the
support brackets supplied a at the
positions indicated flush with the top
edge of the worktop and secure each
bracket with one screw in hole d as
shown.

Building in the gas hob

^ Place the gas hob in the prepared
cut-out.
^ Feed the electricity connection cable
through the cut-out and connect.
^ Make the gas connection.
(see relevant section).
^ Secure the gas hob from below
through the middle elongated hole b
in each support bracket using the
two screws supplied. Carefully adjust
the hob if necessary.