Continuous Drainage - Breville the Smart Dry Instruction Book

CONTINUOUS DRAINAGE

(hose drainage using gravity)
The continuous drainage outlet allows water
to drain without having to monitor and empty
the water tank. Ensure the hose (included)
is properly inserted before starting the
dehumidifier.
1. Remove the water tank to access the
hose connection outlet located at the
back of the unit.
2. Insert the hose into the connection outlet,
ensuring that the hose is slid right to the
back of the connection outlet.
3. As the drainage is dependent on gravity,
for the dehumidifier to drain correctly, no
part of the hose should sit higher than the
hose connection outlet.
4. Place the other end of the hose into a
water drain, being careful that it cannot
inadvertently come loose when water starts
to drain.
5. Carefully replace the water tank with the
hose situated into the hose groove.
6. The dehumidifier will drain through the
hose while installed.
WARNING
Ensure the hose is secure in both the hose
connection and the drainage outlet.
LAD300_200_ANZ_IB_B19.indd 11
DEFROST
This dehumidifier is equipped with an
automatic defrost. The evaporator may
start auto-defrosting if operating in a room
temperature that is less than 23°C.
1. If the
defrosting has automatically started. The fan
will operate on HIGH during defrost and
dehumidification will stop.
2. Automatic defrost will operate for up to
5 minutes.
Drainage
WARNING
hose
connection
Do not disconnect the power or turn off the unit
outlet
during defrost.
DEFROST light turns on,
11
8/4/19 1:56 pm