Table of Contents
Advertisement
Handling
The following explains how to handle the N8551-28F/N8151-44F Built-In AIT.
Setting the AIT data cartridge
Important
• As the data cartridge to be set in the magazine, use our "AIT Data Cartridge (model: AIT2,
AIT1)". If you use a data cartridge of other manufacturer, a read/write error may occur.
• While setting the data cartridge, do not turn off the basic processing unit. This may cause a
malfunction or damage data.
1
Turn on the basic processing unit.
Check that the driver's STATUS
LED, BUSY LED and TAPE LED
go off.
2
Set the AIT data cartridge orienta-
tion as shown below and insert it
into the data cartridge slot.
By inserting the data cartridge to the
extent, it is automatically set in the
driver and the TAPE LED lights.
Important
When write-protect is enabled using the AIT data cartridge
write-protect plug so that you cannot write data in the data
cartridge, the STATUS LED lights.
STATUS LED
14 Built-in AIT
Write-protect plug (Sliding it up
write-protects the cartridge.)
(→ 21 page)
Advertisement
Table of Contents
