Part Name and Function
The Built-In AIT and magazine have the following parts and functions.
Important
The names and functions of each part of the N8551-28F and the N8151-44F and the setup
methods are identical. (Hereafter, the N8151-28F is used for the illustrations in this manual.)
Front
Rear
2
Built-in AIT
Data cartridge slot
A slot in which the AIT cartridge is set
(→ P. 14)
Ventilation holes
(The N8151-44F does not have
ventilation holes.)
EJECT button
Press this button when ejecting the
AIT cartridge from the Built-In AIT.
(→ P. 15)
STATUS LED
An LED which shows the Built-In AIT
status. (→ P. 16)
TAPE LED
An LED which shows the status of the
AIT data cartridge (→ P. 16)
BUSY LED
An LED which shows the data
communication status (→ P. 16)
Fan
Power connector
Connect the Built-In AIT's built-in
power cable. (→ P. 9)
Jumper pin
Pins which set the Built-In AIT
(→ P. 4)
SCSI connector
Connect the Built-In AIT's built-in
SCSI cable. (→ P. 9)