Advertisement
FSIP Installation Prerequisites
•
•
•
•
•
Caution
should be between 1 and 10 megohms.
Interface Processor Slot Locations
The FSIP is installed in the interface processor slots in the Cisco 7000 series and Cisco 7500 series
routers. The interface processor slots in the Cisco 7000 series and Cisco 7500 series routers are as
follows:
•
•
•
•
•
Note
vertically in the Cisco 7000, Cisco 7507, and Cisco 7513.
10 Fast Serial Interface Processor (FSIP) Installation and Configuration
When removing an interface processor, use the handle to pull the interface processor out slowly
while keeping your other hand underneath the carrier to guide it straight out of the slot.
Handle carriers by the handles and carrier edges only; avoid touching the board or connectors.
Place a removed interface processor board-side-up on an antistatic surface or in a static shielding
bag. If you plan to return the component to the factory, immediately place it in a static shielding
bag.
Avoid contact between the interface processor and clothing. The wrist strap only protects the
board from ESD voltages on the body; ESD voltages on clothing can still cause damage.
Never attempt to remove an interface processor printed circuit board from the metal interface
processor carrier.
For safety, periodically check the resistance value of the antistatic strap. The measurement
Cisco 7000—slots 0 through 4 (See Figure 2.)
Cisco 7010—slots 0 through 2 (See Figure 3.)
Cisco 7505—slots 0 through 3 (See Figure 4.)
Cisco 7507—slots 0 and 1, and slots 4 through 6 (See Figure 5.)
Cisco 7513—slots 0 through 5, and slots 8 through 12 (See Figure 6.)
The interface processor slots are oriented horizontally in the Cisco 7010 and Cisco 7505, and
Advertisement
