Entering Gateway Mode; Standby Mode; Forwarding Group Calls; Setting Monitor Options - Motorola MTM800 FuG Feature User Manual

Mobile release 19
Hide thumbs Also See for MTM800 FuG:
Table of Contents

Advertisement

68015000585-MF
Chapter 3: Modes
talkgroup. If the DMO channel is not free, and the incoming call has Emergency priority, then
preemption request is sent.
When the gateway receives a group call addressed to its current selected DMO talkgroup, it forwards
the call on to the respective mapped TMO talkgroup. The DMO radio that initiated the call requires
correct setup for gateway calls (otherwise the call is rejected).
To prevent gateways from switching to background mode due to receiving a radio signal, your service
provider sets up a signal strength threshold. Any signal with strength lesser than the threshold is
ignored and the gateway continues to operate.
When in the background mode, the gateway constantly surveys the DMO channel to determine when it
is free. After 10 seconds of inactivity on the DMO channel, the gateway leaves the background mode.
Gateways roam between TMO sites. To prevent disconnecting an ongoing call due to roaming, the site
switch is delayed until it is no longer in range of the given site.
3.7.1

Entering Gateway Mode

Procedure:
1 From the home screen, press Options.
2 Select Gateway Mode.
NOTICE: When the Gateway Mode is enabled, you cannot make any call.
3.7.2

Standby Mode

Your radio enters Standby mode if there is another Gateway on the same DMO frequency. Gateway
icon flashes and no transmission is forwarded through the gateway. To exit Standby Mode you can:
Choose another DMO talkgroup
Wait untill the other gateway is out of coverage and is no longer present on that DMO talkgroup
3.7.3

Forwarding Group Calls

Your radio shows the source and destination talkgroup of the Group call.
3.7.4

Setting Monitor Options

Procedure:
1 From the home screen, press Options.
2 Press Config.
3 Select one of the following options:
Off – Audio of the calls are not routed to the speakers of the gateway.
Receive Only – Audio of the calls are routed to the speakers of the gateway.
62

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mtm800 fug et

Table of Contents