Honeywell Vocollect Hardware Reference Manual page 245

SRX2 and A700 Battery Charger LED Indicators
The SRX2 battery charger and the A700 battery charger have an LED indicator light, located at the bottom right of
the charger face, that signals the status of the charger.
• Solid green LED: Charger power is on
• No light: Charger power is off
• Solid red LED: Charger is experiencing a power fault (SRX2 only)
Note: If the charger LED indicator is red, unplug the charger power supply from the power source, and
remove all batteries. Plug the power supply into the power source again. If the LED remains red, the
charger may require repair or replacement.
Charger Port Indicators
Additionally, each battery port has two LED indicator lights that apply to the status of the resident battery.
• The ring LED is a circular light that indicates the battery's charge status.
• The alert LED, in the shape of an exclamation point (!), indicates that there is a battery condition requiring
attention. When this indicator is on, the battery on that charger port may not last a full shift. Check VoiceConsole
for a specific alert message.
The following chart describes the patterns for the battery port LED indicator lights.
Ring LED (Charge
Status)
Solid Green
Solid Yellow
Blinking Red
Solid Green
Solid Yellow
Blinking Red
Part Numbers: Wireless Headset Accessories
Part (SRX2 Wireless Headset)
SRX2 Electronics Module
SRX2 Headband with Stability Strap (not assembled)
SRX2 Microphone Caps (Bag of 20)
SRX2 Ear Pads (Bag of 20)
SRX2 Comfort Pads (Bag of 20)
SRX2 T-Bar Pads (Bag of 20)
Figure 174: Battery Port Indicators
Alert LED (Battery
Health)
Off
Off
Off
Solid Red
Solid Red
Solid Red
SRX2 Battery Status
Battery is fully charged
Battery is charging
Charging fault detected
Battery alert condition; fully charged
Battery alert condition; charging
Battery alert condition; fault detected
Part Number
HD-1000-101
HD-1000-102
HD-1000-104B
HD-1000-105B
HD-1000-106B
HD-1000-107B
| Chargers | 245