Storing The Srx2 Hard-Hat Headset - Honeywell Vocollect Hardware Reference Manual

5. Insert the SRX2 electronics module into the pocket on the earcup by aligning the notches on the speaker and
earcup pocket.
6. Push the electronics module into the earcup pocket until it is firmly seated.

Storing the SRX2 Hard-Hat Headset

Honeywell recommends storing the hard hat with the headset earcup moved up on the side of the hat (see figure
below) to reduce the risk of damage.
1. Remove the electronics module from the SRX2 headset. The electronics module can be used by another worker or
stored separately.
2. Detach the microphone cap from the electronics module, and dock it in the mic cap pocket located above the
headset earcup.
Figure 140: Docking the mic cap (SRX2 Hard Hat or High Noise Headsets)
3. Pull the earcup and fork assembly out away from the hard hat until the fork snaps into the outer lock position.
4. Rotate the headset in the hard-hat clip until the earcup rests against the side of the hat.
Figure 139: Adusting the height of the earcup
| Honeywell Wireless Headsets | 190