Honeywell Vocollect Hardware Reference Manual page 206

headset has been paired at least once to a device running VoiceCatalyst version 1.2 or newer voice software, it will
remain in pairing mode for ten minutes then power off.
2. Press and hold the Plus (+) and Minus (-) buttons on the Talkman device for two seconds to manually initiate a
search for wireless headsets.
3. Immediately hold the headset and device so they are within six inches of each other but not touching.
The blue LED indicator on the Talkman device turns on, may flash a few times, and then remains lit. After 20 to
30 seconds, the headset beeps three ascending tones and its LED indicator flashes less rapidly. These indicators
confirm that a pairing has completed.
4. Put on the headset. You will hear the headset repeat the serial number of the device to which it is paired.
5. Verify that the number matches the serial number on the Talkman device.
If you need to attempt the pairing again, re-enter pairing mode by press the Plus (+) and Minus (-) buttons on the
Talkman device again.
6. Press the Play/Pause button on the Talkman device to confirm the number.
7. Press the Play/Pause button again to begin working.
Screen-Based Pairing with a Handheld Device
Screen-based pairing is the preferred method for pairing an SRX headset with a handheld wireless device or PC. This
method allows the user to pick a specific headset from a list of available headset Bluetooth addresses displayed on a
screen, and eliminates the problem of unwanted cross pairing. Auto and manual pairing processes are not available in
screen-based pairing.
Prerequisites:
• The headset is powered off. You can only put an SRX Wireless Headset into low or high power pairing mode from
the powered-off state.
• The handheld device is not in a charger, and there is no wired headset connected to it.
• The device is in sleep mode — not in use running an application.
• The device is Bluetooth ready with Bluetooth connection features enabled.
1. On the SRX headset, press and hold the Plus (+) and Minus (-) buttons for four seconds to place the headset in
pairing mode.
Note: Some handheld devices may require the headset to be in high power pairing mode in order to be
discovered in the device's pairing inquiry. To place the SRX headset in high power pairing mode, press
and hold the Plus (+) and Minus (-) buttons for seven seconds.
By setting the SrxHighPowerPairingDelaySeconds configuration parameter, you can configure how
long an operator must hold the Plus and Minus buttons before entering high-power pairing mode or set the
parameter to have the headset go directly into high-power pairing mode.
2. Initiate the pairing inquiry from the master device by pressing or clicking the appropriate button on the screen.
3. Hold the headset and wireless device so they are within six inches of each other but not touching.
4. Select the ID number of the headset you want to use from the Select SRX Headset list on the screen.
5. Tap or click the appropriate button on the screen to create the pairing.
The screen briefly displays that the device attempts to connect to the headset . Once the headset connects, three
tones play in the headset, the SRX Headset Status displays as Connected. The pairing confirmation step is skipped
because the pairing was specified by the user.
6. Press the Play/Pause button to begin working.
Handheld Device Pairing Status Icons
When using the Vocollect Voice or Voice MP application on a handheld wireless device, an icon in the upper right
hand corner of the screen indicates the pairing status. Vocollect Voice on a PC displays similar browser-based
notifications, but the icons are different.
| Honeywell Wireless Headsets | 206