Download Print this page

Mounting Instructions - Cisco Aironet Power Injector AIR-PWRINJ5 Installation Manual

Advertisement

Installing the Power Injector
2.
3.
4.
5.
6.

Mounting Instructions

You can mount the power injector to most vertical or horizontal surfaces using the mounting tabs on the
top right and bottom left of the unit.
Using the Mounting Tabs
To mount the power injector to a vertical or horizontal surface using the mounting tabs, you will need
the following parts and tools:
Follow these steps to mount the power injector:
1.
2.
3.
4.
5.
6.
Note
Cisco Aironet Power Injector (AIR-PWRINJ5) Installation Guide
4
Plug the other end of the Ethernet cable into the WAN uplink Ethernet port of the access point.
Plug a Category-5 Ethernet cable into the port on the power injector labeled Switch.
Plug the other end of the Ethernet cable into your 10/100/1000 Ethernet switch, hub, or network.
When power is applied, the Status LED blinks green at approximately 1.5 times per second. When
the AP is detected, the Status LED glows solid green. If the power injector is connected incorrectly,
the Status LED blinks green at 10 times per second.
Secure the power injector by mounting it to a vertical or horizontal surface using the mounting
keyholes on the bottom of the unit.
Two #6 plastic wall anchors if mounting to a drywall surface
Two #6 x 1-in. (2.5 cm) sheet-metal screws
A drill and a 3/16-in (0.48-cm) drill bit
A Phillips head screw driver
A small hammer
Using the holes in the power injector mounting tabs as a template, mark the locations on the surface
where you will drill the holes for the wall anchors or screws.
Drill a 3/16-in. (4.7-mm) hole at each marked location.
If you are using #6 wall anchors, use a hammer to install them in the holes.
Hold the power injector to the wall and align the mounting tabs on the power injector with the screw
holes.
Insert the #6 screws through the mounting tabs and into the holes in the wall or surface.
Use a Phillips head screwdriver to drive the screws into the surface.
If the power injector is not securely fastened, continue making small adjustments until you are
satisfied.

Advertisement

loading