Burst Of Steam; Vertical Steam Ironing - Breville Easy Glide Manual

using your iron

Burst of Steam

Note: The temperature selector must be set within the steam setting range (see page
5) when using the shot of steam function. Wait for several seconds between each
press of the steam button.
1. Press the shot of steam button whenever you have a stubborn crease that needs
extra steam. Steam will burst from the holes in the soleplate into the fabric.

Vertical Steam Ironing

Never iron garments when they are being worn.
1. Your iron can be used for vertical steam ironing. This process can be applied to
curtains, dresses on hangers etc.
2. Following the steps on page 4 fill the iron with water.
3. Plug your iron into the mains supply and switch on.
4. Turn the temperature selector until the pointer is within the steam setting range. The
hotter the iron, the more steam is generated.
5. The temperature indicator light will illuminate to show that the iron is heating.
6. When the indicator light goes out, the iron is ready to use. The indicator light will
cycle on and off during ironing as the iron maintains the soleplate temperature.
7. Hold the iron 15cm (6 inches) from the fabric.
8. Press the shot of steam button. The steam will penetrate the fabric removing the
creases. To apply more steam press the shot of steam button again.
Spraying
Note: The spray function will only operate when there is water in the water tank.
1. The water spray can be used to help iron heavy fabrics or difficult areas (collars,
pockets, sleeves, creases, etc). It can also be used when ironing delicate fabrics
which cannot be steam ironed.
2. Simply press the spray button as required to emit a spray of water. If the spray is
being used for the first time, or if the iron has been standing for some time, you
may need to press the spray button a few times to prime the spray before it works
correctly.