Adjusting The Miter Angle; Adjusting The Bevel Angle - Makita LS0714 Instruction Manual

Stopper arm
1
► 1. Adjusting screw 2. Stopper arm
The lower limit position of the blade can be easily
adjusted with the stopper arm. To adjust it, move the
stopper arm in the direction of the arrow as shown in
the figure. Adjust the adjusting screw so that the blade
stops at the desired position when lowering the handle
fully.
Sub-fence
Country specific
WARNING:
When performing left bevel cuts,
flip the sub-fence outward. Otherwise, it may con-
tact the blade or a part of the tool, and may result in
serious injury to the operator.
► 1. Sub-fence
This tool is equipped with the sub-fence. Usually posi-
tion the sub-fence inside. However, when performing
left bevel cuts, flip it outward.

Adjusting the miter angle

1
2
► 1. Turn base 2. Lock lever 3. Miter scale 4. Pointer
Loosen the grip by turning counterclockwise. Turn the
turn base while pressing down the lock lever. When you
have moved the grip to the position where the pointer
points to the desired angle on the miter scale, securely
tighten the grip clockwise.
•
•

Adjusting the bevel angle

1
► 1. Lever 2. Release button
► 1. Pointer 2. Bevel scale 3. Arm
9 ENGLISH
3
5. Grip
CAUTION:
When turning the turn base, be sure to raise the
handle fully.
After changing the miter angle, always secure
the turn base by tightening the grip firmly.
1
2
2
4
5
1
2
3