Table of Contents
Advertisement
NetCam2
_ii_00592en.qxd
NetCam2
2.3
Assigning IP Address and Starting Configuration
It is possible to setup a NetCam2 that is either connected to a local network or
directly connected to a PC using the red-colored crossover cable (supplied).
When setup is executed, the table lists all NetCam2s connected to the local
network.
•
Select the 'MAC address' of the NetCam2 requiring an IP address.
•
When a NetCam2 is selected, the 'selected IP address' is displayed the
default IP address is '211.53.133.92').
•
Enter a password in the 'Admin's Password' box (the default password is
'admin').
•
To change the IP address, click the 'Change IP Addr' button.
•
Enter the new IP address and confirm it with the 'OK' button.
Note: If NetCam2 has a problem, you can reboot it by clicking "Reboot".
2.4
Configuring NetCam2
After assigning a new IP address to the NetCam2, it is possible to enter the
configuration options.
•
Click 'Start Configuration' button to be connected to the Administrator
pages in the NetCam (see Chapter 4).
2.5
Assigning IP Address with ARP command
If you fail to assign an IP address with the setup program, carry out the process
with ARP command.
NetCam2 IP address = IP address to be assigned to the NetCam2.
NetCam2 Ethernet address = MAC printed on the bottom of the NetCam2.
My PC IP address = IP address of the Network Interface Card in your PC>
Note: The NetCam2 and PC IP addresses must be within the same IP address class.
14
All manuals and user guides at all-guides.com
1/23/03
2:22 PM
Page 14
Section 2
Advertisement
Table of Contents
