Advertisement
1-3. Installation Procedures
m
. Power off the unit and disconnect the power
cord or battery beforehand to avoid damage to
the circuit of the unit.
. Carry out the work on a protective sheet to
avoid scratches on the cabinet.
1. Loosen the six screws with stopper to detach
the top panel.
2. Disconnect the harness from the connector
CN103 on the SMB-26 board.
3. Loosen the four screws with stopper to detach
the battery panel.
4. Disconnect the harnesses from the connector
CN4 on the CR-51 board and the connector
CN10 on the RE-244 board.
5. Remove the four screws to detach the board
retainer in the arrow direction.
n
When installing the board retainer, insert it
into the two slits of the chassis and secure it
with the four screws.
6. Detach the board spacer.
7. Disconnect the harness (AXM-VPR) from the
connector CN3 on the AXM-37 board.
1-2 (E)
CN103
Screws with stopper
CN10
Slits
Harness (AXM-VPR)
CN3
Screws with stopper
Top panel
CN4
Screws with stopper
Battery panel
Board spacer
Board retainer
PSW2.6 x 5
PSW2.6 x 5
HKSR-9003
Advertisement
