Advertisement
1-4. Disconnecting/Connecting a Coaxial Cable
1-4-1. Fine-Wire Coaxial Cable (With the Connector)
Fine-wire coaxial cables are connected to the
following boards. Be sure to observe the discon-
necting and connecting procedures below to
prevent wire disconnection or poor contact.
. VPR-101 board
. AD-188 board
. SS-103 board
Disconnection
1. Remove the cable stopper (30P). (Refer to
Section 1-3.)
2. Hook portions A of the cable stopper (30P) to
the connector of the fi ne-wire coaxial cable,
and pull the connector straight in the arrow
direction to disconnect it.
n
Never pull the fi ne-wire coaxial cable.
Connection
1. Dry clean the contact surface with a wiping
cloth in the arrow a direction.
2. Hold both sides of the fi ne-wire coaxial cable
connector with the contact surface facing up.
3. Insert the connector straight to meet the angle
specifi ed in Figure 1.
n
Insert the connector carefully so that the
connector guides are not caught by the edge
of the mating connector.
HKSR-9003
Hole
A
NG Do not pull the cable.
Gold
Direction of dry cleaning
a
Guide
Mating connector
Figure 1
2° or less
Cable stopper (30P)
Hole
A
Fine-wire coaxial cable
Connector
Fine-wire coaxial cable
Connector
Guide
Connect surface
5° or less
1-9 (E)
Advertisement
