Table 4-50 Cd-Rtb Led Indications; Installation - NEC Univerge SV8100 System Hardware Manual

Issue 2.0
4 - 110
The blade plugs into a universal slot and does not consume any port.
Each blade provides eight RJ-45 port connectors. These connect to
LAN terminals. Depending on the type of LAN terminal, the blade
may not detect the difference between straight cable and crossover
cable automatically. If auto-crossover is not functioning, use straight
cable for that terminal connection.
Refer to the following tables for maximum upgrade capacities of the
CD-RTB blade:
Table 2-6 SV8100 Maximum 9.5" Gateway and 19" System Capacities

– Blades on page 2-13
Table 2-7 SV8100 Maximum 9.5" Base and Expansion System

Capacities – Blades on page 2-15
6.4.2

Installation

To install the CD-RTB:
1. Plug the CD-RTB blade in any universal slot.
2. Refer to the Univerge SV8100 Programming Manual for
required programming.
6.4.3 LED Indications
LED indications for the CD-RTB are indicated in
LED Indications. Each LED is listed with its associated function and
LED and Operational status. Refer to
page 4-108
LED Function
CN2, CN3 LAN
LINK/ACT Operation
Status
CN2, CN3 LAN Speed
10/100 Status
for the location of the LEDs on the blade.

Table 4-50 CD-RTB LED Indications

LED Status
Green On
Green
Flashing
Green Off
Orange On
Orange Off
UNIVERGE SV8100
Table 4-50 CD-RTB
Figure 4-47 CD-RTB Blade on
Operation
Comments
Status
Link Established Individually for
Ports 1~8
Communicating Individually for
Data Ports 1~8
Not Activated Individually for
Ports 1~8
100Mbps Individually for
Ports 1~8
10Mbps Individually for
Ports 1~8
Installing the SV8100 Blades