Figure 7-1 Sip Dect System Configuration; Section 2 Nec Sip Dect Solutions - NEC Univerge SV8100 System Hardware Manual

Issue 2.0

Figure 7-1 SIP DECT System Configuration

Configuration. All connections are IP connections over Ethernet.
2.1
7 - 2
DAP Manager
IP Switch
PVA
Figure 7-1 SIP DECT System Configuration
Installation
The hardware installation consists of the following steps:
1. Determine the number of DAPs that need to be installed and where they
should be located. Refer to NEC SIP DECT Solutions Technician's
Guide, DAP Planning
2. Read the sections
SIP DECT Solutions Technician Guide carefully to determine how the
DAPs should be powered and how the cable must be run.
3. Make sure that you have an IP Switch available to connect the IP DECT
equipment. Power up the IP Switch.
4. Setup and connect the power provision for the DAPs. The LEDs on the
DAPs should show some activity.
5. Connect the DAP cables to the IP Switch.

Do not connect the Ethernet cables or the IP Switch to the local IP network. The
DECT configuration should be installed in a closed network.
shows the SIP DECT System
DAP
IP Switch
CPU
CPUII IPK II
NEC System
as a guideline.
DAP Cabling and DAP Power Provision in the
Installing SV8100 Wireless Telephones
UNIVERGE SV8100
DAP DAP
NEC