Table of Contents
Advertisement
V.
Service Features
A.
Serviceability
To ensure machine reliability, Canon U.S.A., Inc. recommends that a
Quality Assurance Visit is performed to clean and inspect the Nagel
Finisher when performing QA for the CLC 5000. Refer to the CLC 5000 for
further details.
B.
Software Requirements
The CLC 5000 should be Version 4.03 or higher; the ColorPASS-Z5000
should be V1.2 or higher, and DocBuilder Pro™ requires use of a Dongle
at the workstation used.
C.
Estimated Installation Time
The installation time will vary based upon system configurations.
Nagel Booklet Maker/FN5
Nagel Trimmer/TP5 (Option)
Shift Tray (Option)
D.
Space Requirements
This section specifies the minimum amount of space required for the
system. The area where the system is to be located should provide easy
access to all sides of the equipment for service, allowing at least one foot
on either side and at least one foot in the rear.
NOTE:
Due to the weight of the Nagel Finisher, it is recommended that at
least four people be used to lift each section off the palate.
5
Estimated installation times are based on hardware installation with an experienced technician only.
Nagel Finisher Service Support Guide
Description
3
(With Buffer Pass)
Rev. 0
Nagel Finisher Service Support Guide
Estimated Time
40 minutes
30 minutes
20 minutes
September 2001 Page 5
5
Advertisement
Table of Contents
