Huawei ECC800 User Manual page 39

Data center controller
Hide thumbs Also See for ECC800:
Table of Contents

Advertisement

ECC800 Data Center Controller
User Manual
Item
AI/DI port
DO/DI port
RS485 serial
port expansion
Wiegand
interface
BLINK button
Address DIP
switch
E-label
Indicators
Table 3-20 Access actuator indicator description
Indicator
PWR
RUN
Issue 05 (2019-09-16)
Specifications
Two AI/DI ports, can connect to the fire alarm and exit button
One 12 V DC power output that controls magnetic locks, terminal
One DI input port for connecting to the door status switch
Two RS485 ports (one route) with the default communications rate of
9600 bit/s, physical port cascading supported (reserved function)
Two Wiegand interfaces, 12 V DC card reader operating power output;
two routes of card readers (non-fingerprint readers) can operate at the
same time.
Press the button for less than 1 second to start blinking.
Hold down the button for 1–5 seconds to search for a network and
start networking.
Hold down the button for more than 10 seconds to clear network
parameters.
4-pin address DIP switch
Supported
Color
Green
Green
Copyright © Huawei Technologies Co., Ltd.
Name
Power input status
indicator
Communication status
indicator
3 Device Description
Status
Steady on: The power
input is normal.
Off: There is no
power input.
Off: The power is
abnormal or the
board program is
loading.
Blinking at long
intervals: The access
actuator successfully
registers with the
ECC800 and the
software runs
properly (the
indicator blinks at 0.5
Hz, on for 1s and
then off for 1s).
Blinking at short
intervals: The
29

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents