How To Set And Add A Pdu2000 - Huawei ECC800 User Manual

ECC800 Data Center Controller
User Manual
2.
Table 8-5 Adding a PDU8000
Path
Choose System
Settings >
Device
Management
and click Add
Device. The
parameters for
adding devices
are displayed.
3.
----End

8.1.8.6 How to Set and Add a PDU2000?

Prerequisites
One end of the straight-through cable has been connected to the COM 1 or COM 2 port on the
PDU2000, and the other end has been connected to the COM port on the ECC800 collector,
rack environment unit, or ETH converter.
Context
Table 8-6 PDU2000 basic Information
Vendor
Clever
Haipengxin
Issue 05 (2019-09-16)
Add a PDU8000.
Parameter
Name
Device attribute
Device Type
Connect To
Communications
Port
Device Address
Click Test Connect to check whether the PDU8000 connects to the ECC800 properly.
− If the PDU8000 connects to the ECC800 properly, click Confirm. The connected
devices are displayed in the Number of connected devices list.
− If the PDU8000 does not connect to the ECC800 properly, check whether the cable
between the PDU8000 and the ECC800 is connected properly, whether the
PDU8000 and ECC800 are running properly, and whether the input parameters are
consistent with the PDU8000 parameters.
Name Displayed on
the WebUI
PDU2000-M (C)
PDU2000-M (H)
Copyright © Huawei Technologies Co., Ltd.
Setting
Select PDU from the drop-down list box.
Select PDU8000 from the drop-down list box.
Select ECC800 from the drop-down list box.
Select COM1 from the drop-down list box.
NOTE
The setting example indicates that the PDU8000 is
connected to the COM1 port on the ECC800. If the
PDU8000 is connected to another port, enter the number
of the connected port.
In this example, Device Address is set to 1. During
actual configuration, set the device address for the
PDU8000 based on the actual situation.
Eleventh and Twelfth Characters in
Device Barcode
a
FT
6B
8 FAQ
188