Error Messages - Brother HL-L2300D Service Manual

3.2 Error Messages

First line
Cartridge Error
Connection Error ―
Connection Fail
Cooling Down
Cover is Open
Drum !
Drum End Soon
Jam 2-sided
Jam Inside
Jam Rear
Second line
Put the Toner
Cartridge back in.
―
Wait for a while
Close the Front Cover. The front cover sensor detected
Close the Fuser Cover
which can be found
behind the Back Cover
of the machine.
Make sure there is no
paper jammed inside
the machine and close
the Back Cover, then
press Go.
Slide the Green tab on
Drum Unit.
―
Pull out the Duplex
Tray at the back of the
machine and remove
the jammed paper.
Open the Front Cover,
pull out the Drum Unit
completely and
remove the jammed
paper.
Open the Back Cover
and remove the
jammed paper, then
press Go.
2-16
Description
The new toner sensor could not
detect the new toner cartridge
correctly.
Multiple access points were found
as a result of the access point
search.
Connection failed although the
access point was found as a result
of the access point search.
The side thermistor of the fuser
unit detected a temperature higher
than the specified value.
that the front cover was open.
The eject sensor detected that the
fuser cover was open.
The eject sensor was ON when
the power switch was turned ON.
Detected discharge that may be
attributable to dirty corona wire on
the drum unit.
The number of rotations of the
drum unit is reaching the upper
limit.
The registration front sensor does
not detect paper pass within the
specified time after the first side
was printed in duplex printing
mode.
The eject sensor does not detect
paper pass after the registration
rear sensor detected the paper
pass.
The eject sensor remains ON
(paper pass detected) even after
the registration rear sensor
detected the end of paper pass.
Error Refer
codes to:
4F01 2-34
--- 4.5.2
--- 4.5.2
6801 2-36
6001 2-35
6004 2-35
7C00 2-41
6A00 2-38
4000 2-33
7700 2-41
7000 2-39
7100 2-40
Confidential