Brother HL-L2300D Service Manual page 61

 Error code 8A01
Size Error DX
Specify the correct paper.
The registration rear sensor detected that the paper fed was smaller or larger than the
specified size in duplex printing mode.
<User Check>
• Use appropriate paper (Letter to Legal).
Step
Registration rear actuator
1 caught in some sections of the
machine
Registration rear sensor failure
2
Main PCB failure
3
 Error code 8C00
Manual Feed
Load paper.
There is no paper set in the manual feed slot on the manual feed slot fix mode.
<User Check>
• Set paper in the manual feed slot.
Step
Registration front actuator
1 caught in some sections of the
machine
Connection failure of the
2
registration rear sensor harness
Connection failure of the HVPS
3
flat cable
HVPS flat cable breakage
4
Registration rear sensor failure
5
High-voltage power supply PCB
6
failure
Main PCB failure
7
Cause
Reattach the registration rear actuator.
Replace the registration front/rear actuator
holder ASSY.
Replace the main PCB ASSY.
Cause
Reattach the registration front actuator.
Reconnect the registration front/rear sensor
PCB harness.
Reconnect the HVPS flat cable.
Replace the HVPS flat cable.
Replace the registration front/rear actuator
holder ASSY.
Replace the high-voltage power supply PCB
ASSY.
Replace the main PCB ASSY.
2-43
Remedy
Remedy
Confidential