Table of Contents
Advertisement
The angles cannot be changed.
Multi-angles are not recorded on the
DVD VIDEO being played back.
The DVD VIDEO prohibits changing
the angles.
Tuner
The radio presetting is canceled.
The power cord is disconnected or a
power failure occurred for longer than
a day. Redo "Presetting a radio station"
(page 65).
There is severe hum or noise.
("TUNED" or "STEREO" flashes in the
display.)
Set the proper band and frequency
(page 64).
Connect the antenna properly
(page 23).
Find a place and an orientation that
provide good reception, then set up
the antenna again. If you cannot obtain
good reception, we recommend that
you connect a commercially available
external antenna.
The supplied FM lead antenna receives
signals along its entire length, so make
sure you extend it fully.
Locate the antennas as far away from
the speaker cords and the power cord
as possible, to avoid picking up noise.
Try turning off the surrounding
electrical equipment.
A stereo FM program cannot be
received in stereo.
Press REPEAT/FM MODE repeatedly
until "MONO" disappears from the
display.
Optional components
There is no sound.
Refer to General item "There is no
sound. " (page 107) and check the
condition of the system.
Connect the component properly
(page 104) while checking:
if the cords are connected properly.
if the cord plugs are firmly inserted
all the way.
Turn on the connected component.
Refer to the operating instructions
supplied with the connected
component and start playback.
To change the AM tuning interval
The AM tuning interval is factory-preset
to 9 kHz or 10 kHz (for some areas).
1
Press FUNCTION +/ or TUNER/
BAND repeatedly to select "AM".
2
Press / to turn off the system.
Continued
11
GB
Hide quick links:
Advertisement
Table of Contents
