Troubleshooting - Breville Smart Dry Ultimate LAD500 Instruction Book

Troubleshooting

TROUBLESHOOTING GUIDE
Before carrying out any of the following service checks, unplug the unit from the power outlet.
PROBLEM
Dehumidifier not
working.
Dehumidification has
reduced in power.
Loud noises coming
from the dehumidifier.
The dehumidifier
suddenly stops.
Clothing dries
very slowly.
No reduction of
humidity in the room.
WARNING
This dehumidifier uses a refrigerant compressor. The noise from the compressor turning off and
on during operation is normal.
16
LAD500_ANZ_IB_C19.indd 16
POSSIBLE CAUSES
•
Power plug is disconnected.
•
The tank is full of water.
•
The tank is not in the right
position.
•
The filter is too dirty.
•
The air inlet or outlet are
blocked.
•
The dehumidifier is on an
uneven surface.
•
The room humidity level may
be outside of the radar of the
dehumidifier.
•
The room temperature is
too low.
•
The wet clothes are not
exposed to the air from the
unit.
•
The room is too large for the
unit's scope.
•
Doors and windows in the
room are open.
WHAT TO DO
•
Plug the power cord into the power socket.
•
Empty the water tank.
•
Position the water tank correctly in the unit.
•
Clean the filter.
•
Remove the object that is blocking the air
inlet or outlet.
•
Position the dehumidifier on a smooth and
stable surface.
•
The dehumidifier will start again
automatically when it can read the room
humidity level again.
•
If the room temperature is too low, the
clothing will dry slower than usual.
•
Place the wet clothes closer to the unit so
they are exposed to the air flow.
•
Move to a smaller room.
•
Close any doors or windows in the room.
8/4/19 1:38 pm