Chapter 15 - Configurable Parameter Reference Guide - Honeywell Touchpoint Plus Wireless Technical Handbook

3020M5001_Iss 1_07/18
Chapter 15 – Configurable Parameter Reference Guide
Parameter Name
Alarm 1 Enable
Alarm 1 Function
Alarm 1 Level
Alarm 1 Trigger
Alarm 2 Enable
Alarm 2 Function
Alarm 2 Level
Alarm 2 Trigger
Alarm 3 Enable
Alarm 3 Function
Alarm 3 Level
Alarm 3 Trigger
Alarm Hysteresis
Alarm Latch
Configurable Parameter Reference Guide
Parameter Description
Alarm enable/disable.
0 = Disabled 1 = Enabled
Type of alarm function. Default is threshold. 0=Threshold, 1=STEL,
2=TWA
Alarm 1 threshold concentration
Alarm trigger option. 0 = Rising 1 = Falling
Alarm enable/disable. 0 = Disabled 1 = Enabled
Type of alarm function. Default is threshold. 0=Threshold, 1=STEL,
2=TWA
Alarm 2 threshold concentration
Alarm trigger option. 0 = Rising 1 = Falling
Alarm enable/disable. 0 = Disabled 1 = Enabled
Type of alarm function. Default is threshold. 0=Threshold, 1=STEL,
2=TWA
Alarm 3 threshold concentration
Alarm trigger option. 0 = Rising 1 = Falling
Alarm hysteresis is to avoid the alarm from frequent on/off when the
gas reading is close to the alarm threshold. When clearing the gas
alarm, the gas reading should go below gas alarm threshold
hysteresis.
The hysteresis is defined in % of Full range (Default 2%)
Alarm latch option. Alarm will be continued until manual user reset if
latching is enabled.
0: Disabled, 1: Enabled
Applies to
All
All
All
All
All
All
All
All
All
All
All
All
All
All
87
Touchpoint Plus wireless
Default Measurement
Read/Write
Value units
RW 1 n/a
RW 0 n/a
RW 20 %FSD conc.
1 for O , 0 for
2
RW n/a
other gases
RW 1 n/a
RW 0 n/a
RW 40 %FSD conc.
1 for O , 0 for
2
RW n/a
other gases
RW 1 n/a
RW 0 n/a
RW 60 %FSD conc.
RW 0 n/a
RW 2 %FSD
RW 1 n/a
Technical Handbook