RIDGID RT12000 Owner's Manual page 12

OPERATION
Blowing Feature
Your Vac features a Blower Port. It can
blow sawdust and other debris. Follow the
steps below to use your Vac as a Blower.
1. Locate the Blower Port, at the rear of
the Powerhead of your Wet/Dry Vac.
2. Align the Professional Locking Hose
Release Button end with the Blower
Port Ridges.
straight into the Blower Port until the
Hose Release Button fully engages the
Blower Port Ridges.
3. (Optional) Attach the Extension Wand
to swivel end of the Hose.
4. Turn the Vac on and you are ready to
use your Vac as a Blower.
!
WARNING: Always wear safety
eyewear complying with ANSI Z87.1
(or in Canada, CSA Z94.3) before
using as a blower.
!
WARNING: To reduce the risk
of injury to bystanders, keep them
clear of blowing debris.
!
CAUTION: Wear a dust mask if
blowing creates dust which might
be inhaled.
SP7054 RT12000.indb 12
Push the Hose End
Hose Release Button
Professional
Locking Hose
Swivel End of Hose
Remove Hose:
1. Rotate Hose End in either direction to
disengage Blower Port Ridges.
2. Press the Hose Release Button and
pull the Hose End straight out of the
Blower Port.
1
1
2
Hose Release Button
REMOVE HOSE
12
Blower
Port
Ridges
Extension
Wand
(Optional)
Blower
Port
Ridges
INSERT HOSE
9/5/18 12:04 PM