Unit Setup (Common Settings); Basic Operations In The Common Settings Menu; Input/Output - Sony REA-C1000 Operating Instructions Manual

Unit Setup (Common Settings)

This section describes the common settings of the unit
on each menu page.
This configuration is performed by the administrator.
Basic Operations in the
Common Settings Menu
Click an item in the common settings menu on the left
side of the screen to display the setup screen for that
item.
If the setup screen displays multiple tabs, click on a tab
to switch the display in the setup screen.
The following buttons at the bottom of the setup screen
are common for all items.
[OK]: Click to apply the settings. The settings are not
applied on the unit until you click this button.
[Cancel]: Click to discard the settings and return to the
previous state.
Note
Only those items that are currently configurable are
displayed. Items that are grayed out cannot be
configured. Functions that are not installed are not
displayed.

Input/Output

Use to configure the connected camera that supplies the
video input of the unit.
You can preview and adjust the video from the camera
or device connected to the HDMI IN 1 connector.
Preview image
When the camera or other video device connected to the
HDMI IN 1 connector is operating normally, a preview
of the image from the camera is displayed.
[Nickname]
Enter a nickname for the connected camera or device.
This is used as an identifier when configuring
applications.
[IP Address]
Enter the IP address of the remote camera to control a
Sony remote camera from the unit using VISCA over IP.
[Model Name]
Select the model name or enter an arbitrary model name
for the remote camera to control from the unit using
VISCA over IP.
Notes
• When using the PTZ Auto Tracking application, [IP
Address] and [Model Name] entry is required. If these
are left blank or the settings are incorrect, the
application may not function correctly.
• When using the Handwriting Extraction application,
you can use the remote camera functions in the
application by adding entries for [IP Address] and
[Model Name].
11