Preparation; Precautions; Preparing The Remote Commander; Setting Up The Unit - Sony VID-P150 Operating Instructions Manual

Preparation

Precautions

• Unplug the VID-P150 from the wall outlet when it is
not being used for a long period of time. To
disconnect the cord, pull it out by grasping the plug.
Never pull it out by the cord itself.
• The fluorescent lamps can get hot during operation.
Do not touch the lamps during operation and when
collapsing the VID-P150.
• Clean the cabinet with a soft cloth lightly moistened
with a mild detergent solution. Never use any type of
solvent such as alcohol or benzine, which might
damage the finish.
• Clean the lens with an air spray or soft dry cloth,
taking care not to scratch it.
• When the fluorescent lamps flash or get darkened, the
fluorescent lamps should be replaced with new ones.
In this case, contact your Sony dealer.
Preparing the Remote
Commander
Insert two R6 (size AA) batteries by matching the '
and ' on the batteries to the diagram inside the battery
compartment.
Note
When the batteries for the remote commander are
weak, the remote control range shortens. When this
happens, replace both batteries.

Setting Up the Unit

1
Lift up the camera stand while keeping the
UNLOCK lever pressed down.
If you cannot press down the UNLOCK lever, fold
the camera stand down toward the operation panel
until it touches the stage, then press down the
UNLOCK lever again.
Camera stand
2
Move the camera downward.
When the camera is in the flip-up position, move
the cover manually in the direction of the arrow.
Turning on the POWER returns the camera lens to
the home position.
Cover
3
Open both arm lights until they fix in place.
Arm light
4
Connect the power cord to the AC IN connector on
the rear panel.
UNLOCK lever
Arm light
11