Configuring The Ip Interface; Slave-To-Slave Communication - Siemens SINAMICS G120 Operating Instructions Manual

Low voltage converters, chassis and wall/panel mounted devices with cu230p-2 control units
Hide thumbs Also See for SINAMICS G120:
Table of Contents

Advertisement

6.2.10.7

Configuring the IP interface

Configure communication with STARTER
STARTER provides a screen form to set the communication with the control system.
Open the dialog screen form "Control_Unit/Communication/Commissioning interface" and
activate the "Configure IP interfaces" tab
● Set the DHCP mode to 0 (factory setting).
● Enter the device name, address, gateway and the address for the subnet mask.
● In the Activation field select "[2] Save and activate configuration".
● To activate the settings, you must switch off the inverter power supply and then switch on
again.
You can also enter or read out data using the expert list. You can find the corresponding
parameters in the number range r8909 ... p8925
6.2.10.8

Slave-to-slave communication

"Direct data exchange" is sometimes called "slave-to-slave communication" or "data
exchange broadcast". Here, slaves exchange data without any direct involvement of the
master.
You can find more information in: "Manuals for your inverter in the fieldbus function manual
(Page 451)".
Converter with CU230P-2 Control Units
Operating Instructions, 04/2015, FW V4.7 SP3, A5E34257946B AB
Advanced commissioning
6.2 Inverter control
187

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sinamics g120cSinamics g120p

Table of Contents

Save PDF