Siemens SINAMICS G120 Operating Instructions Manual page 137

Figure 5-4
6. When the USB interface is appropriately set, then the "Accessible nodes" screen form
shows the inverters that can be accessed.
Figure 5-5
Figure 5-6
If you have not correctly set the USB interface, then the following "No additional nodes
found" message is displayed. In this case, follow the description below.
7. Proceed as follows:
You have transferred an inverter accessible via the USB interface into your project.
Converter with CU230P-2 Control Units
Operating Instructions, 04/2015, FW V4.7 SP3, A5E34257946B AB
"Accessible nodes" in Startdrive
Inverters found in STARTER
Inverters found in Startdrive
With STARTER
Select the inverter ☑.
•
Press the "Accept" button.
•
With Startdrive
Accept the inverter into the project using the menu:
•
"Online - Upload device as new station (hardware and
•
software)"
Commissioning
5.4 Commissioning with a PC
137