Section 4: Operations; Operation - Grizzly T28798 Owner's Manual

SECTION 4: OPERATIONS

Operation

This metal dust collector draws metal dust into
a collection drawer and discharges air through a
3-stage air-filter system.
Metal dust is collected in a primary 1.0-cubic-foot
drawer that slides into the main compartment
behind the access door, as shown in Figure 16. A
secondary dust tray in the air filter compartment
holds 0.23 cubic feet of material (see Figure 16,
inset).
Collection Drawer
Filter
Door
Opening
Figure 16. Collection drawer and dust tray
locations.
When machine is not in use, insert disabling pin
into ON/OFF switch to avoid accidental startup.
If you are not experienced with this type
of machine, WE STRONGLY RECOMMEND
that you seek additional training outside of
this manual. Read books/magazines or get
formal training before beginning any proj-
ects. Regardless of the content in this sec-
tion, Grizzly Industrial will not be held liable
for accidents caused by lack of training.
-20-
Access
Door
Dust Tray
To reduce your risk of
serious injury, read this
entire
using machine.
Never operate machine with damaged or
worn parts. Never operate machine with
filters, guards, or covers removed.
Eye and face injuries and respiratory prob-
lems can occur while operating or cleaning
this tool. Wear personal protective equip-
ment to reduce your risk from these haz-
ards. Wear NIOSH-approved respirator,
ANSI-approved safety goggles and leather
gloves whenever checking or emptying col-
lection drawer and air filter dust tray. Keep
metal dust off clothing and skin.
To use metal dust collector:
1. Turn metal dust collector ON.
2. Turn dust-producing machine ON and per-
form operation.
3. Turn dust-producing machine OFF when
operation is complete.
4. Turn metal dust collector OFF when finished
with operation or to check/clean collection
drawer. Empty drawer and tray when approxi-
mately ⁄ – ⁄ full.
1 1
3 2
Model T28798 (Mfd. Since 12/18)
manual BEFORE