Commissioning Information - Honeywell GENT VIG-RPT-72 Installation Manual

Commissioning information

Password or PIN code
"
The terms Password, PIN (Personal
Identification Number), Usercode and Access code
mean the same and are used interchangeably.
A password restricts access to the controls available to the
user at the Repeat panel.
There are four access levels to the controls.
¨
The Access level 1 controls only allows
cycling through of multiple fire events
messages on the screen using the two
buttons on the outer door.
¨
Access level 2a is for the CUSTOMER. Here
the person responsible for the system can
access the 'essential controls' by opening the
panel outer door using a key
¨
Access level 2b is for the CUSTOMER. Here
the person responsible for the system can
access essential controls and some
configuration menus using the panel door key
plus a customer PIN.
¨
Access level 3 is for the ENGINEER. Here
the person responsible for the system can
access essential controls and all system
menus using the panel door key plus Engineer
PIN.
¨
Daily PIN
There is another PIN that changes daily,
which is available to the servicing
organisation. This daily PIN provides the same
access to controls as the Engineers' PIN. The
daily PIN is only used when the Engineer's
PIN is not known.
"
Always make a note of the Customer and
Engineering PINs once they are created. Ensure the
Customer PIN is passed on to the person responsible
for the fire alarm system on the site.
2
www.acornfiresecurity.com
How to create an Engineer PIN
The menu options under the Engineer PIN provides access to access
level 3 controls that can alter the configuration of the system.
To create or change an existing Engineer PIN:
(You will need to be at Access level 3 if an Engineer PIN is already
set up.)
¨
¨
How to change the Customer PIN
The Customer PIN provides access to access level 2 restricted menu
options that cannot alter the configuration of the system. To change a
Customer PIN:
You will need to be at Access level 2.
¨
¨
How to erase a PIN
The Engineer or Customer PIN can be erased. To erase the PIN of
either Customer or Engineer level you will need to be at the
respective access level.
¨
www.acornfiresecurity.com
Vigilon Repeat panel (EN/BS)
"
All Vigilon panels leave the factory with no Engineer PIN code
(Access level 3 code). Therefore, on first power up there is an
open access to all the Access level 3 menus.
Press the Menu On/ Off button and select [Test/Eng]
->[UserCode]# -> then momentarily press <etc> to
select [Config] -> [New Pass] and then type a new
PIN or change an existing PIN and press the Enter
key.
# - will appear if a PIN is already setup.
It is recommended that the PIN is at least 4 numbers
and no greater than 15 numbers and letters in the
password code.
"
This repeat panel automatically sets up a
FACTORY DEFAULT CUSTOMER PIN: 2 2 2 2, that is after
an Engineer PIN is made active.
Press the Menu On/Off button and then [Test/Eng]
-> [UserCode] -> enter the existing Customer PIN
and select [Enter], select [New Pass] and then type
a PIN of less than 15 characters in length and press
the Enter key.
It is recommended that the PIN is at least 4 numbers
and no greater than 15 numbers for Vigilon
and Vigilon Compact VA panels. The Vigilon panels
can use numbers and letters in the password code.
Press the Menu On/Off button and then [Test/Eng]
-> [UserCode] -> enter the existing Customer
PIN/Engineer PIN and select [Enter], select [New
Pass] and then just press the Enter key, this will
erase the PIN. If the Engineer PIN is erased then
Customer PIN is also erased giving open access to all
the menus.
4188-839_issue 7_08/12_pt2_EN/BS Repeat_inst
compact