Makita RU03 Instruction Manual page 10

For plastic blade head:
Attach the wire guard to the holes on the rear side of the
protector. The blade mark on the protector indicates the
hole to be used.
► 1. Hole
When wire guard is not in use, lift it for the idle position.
► 1. Wire guard
Installing the protector
CAUTION:
While installing the protector, be
careful not to contact the nylon cord cutter on
the protector. Contact with the cutter could result in
personal injury.
2
► 1. Screw 2. Protector
Mount the protector by fitting it on to the motor housing,
and then secure it with two screws.
Installing nylon cutting head
Optional accessory
tally impacts a rock or hard object during oper-
ation, stop the tool and inspect for any damage.
If the nylon cutting head is damaged, replace it
immediately. Use of a damaged cutting tool could
result in serious personal injury.
after installation.
nylon cutting head, be careful not to contact the
nylon cord cutter on the protector. Contact with the
1
cutter may result in personal injury.
NOTICE:
cutting head.
1.
the cutting tool easily.
2.
motor housing and rotate the spindle until the spindle is
1
locked.
► 1. Hex wrench 2. Hole 3. Spindle
3.
tighten it by turning it clockwise.
1
► 1. Nylon cutting head
4.
To remove the nylon cutting head, turn it counterclock-
wise while locking the spindle with the hex wrench.
10 ENGLISH
CAUTION:
If the nylon cutting head acciden-
CAUTION:
Be sure to remove the hex wrench
CAUTION:
When installing or removing the
Be sure to use genuine Makita nylon
Turn the tool upside down so that you can replace
Insert the hex wrench through the hole on the
1
Place the nylon cutting head onto the spindle and
Remove the hex wrench.
3
2
1