Commit/Commit Later; Discard; Finish - Honeywell X Series User Manual

Printing Screens
All the Status screens have a Print button, to execute this, the printer must first be configured
in "Network Admin" on page 75 and in the "Printer Menu" on page 111. For details on
suitable printer types see "Print Support" on page 29.
The Printer function is a firmware option that is selectable from the Factory menu > "Cred-
its" on page 102.

Finish

When the Finish button is pressed at the end of a new set up or a change to a setup the
following options are available.
Commit
This will save the new setup or changes to an existing setup, over-writing the existing one,
and implement them into the recorder
Field validation is performed when a change has been made, if a problem is identified, an
error message is shown and the field in question clearly marked.

Discard

This will ignore the new setup, or the changes that have been made to the existing setup,
and not implement them into the recorder
Commit Later
This gives the user the option for a configuration to be partially completed but to be commit-
ted at a later date. This will retain the new set up or the changes to the existing setup until
they are required. A partially completed setup will not be maintained over a power failure.
If Commit Later has been executed, a warning message will display for Edit Setup, Edit Lay-
out and User Admin (Passwords) screens. This is to alert the user that the changes have
been made to the configuration and not committed in the recorder. The user can Discard the
changes or continue to do changes and then Commit them.
168 43-TV-25-30 Iss.6 GLO Aug 07 UK