Advertisement
Field ✻ 55
The allowable combinations of communication reporting channels and reporting options are shown in the
table below. The available options, which depend upon whether AAV is enabled in field *91, are programmed
in field *55. Program the preferred reporting channel in field *77.
If the GSM/IP (Digital Communication with AAV) feature is used (options 5 and 7 in *55), there may be restrictions when
dialing the numbers entered in *41, *42 and *46 (i.e.; #, ✻ , pause may not be allowed, or phone number extensions may
not be dialed, etc) depending on the service provider.
Reporting Option
Primary Phone only
Redundant reports to both channels
Primary Phone is the preferred channel
LRR/IP is the preferred channel
LRR/IP Only
NOTES
1.
AAV mode can be established only on Telco Line.
2.
AAV mode can be established either on Telco Line or LRR/IP (Digital Communication with Voice Capabilities)
3.
Primary phone number programmed in *41 is shared between Telco Line and LRR/IP (Digital Communication with Voice Capabilities)
4.
Follow Me System, Follow Me Reminder and Pager features are not supported. These features will not work if selected in *49.
5.
Speaker Phone and Remote Phone Access are not available. These features should be disabled in *47 and *91. Download over the
Phone Line feature is also unavailable.
6.
AAV mode can be established only on LRR/IP (Digital Communication with AAV Capabilities)
7.
If AAV is selected and LRR/IP communications device is enabled, you must enter "0" (primary dialer preferred channel) as the second
entry in Field *77.
The PABX phone number entered in field ✻ 40 is not dialed on GSM/IP (Digital Communication with AAV). However, it is used for dialing
8.
on the Telco Line.
Legend
LRR/IP (Digital Communication only) = Digital GSM Communication Channel
LRR/IP (Digital Communication with AAV) = GSM Communication Channel with voice capabilities (a radio with voice
capability is required to use AAV options)
Telco Line = Land Phone Line
Reporting Channels
✻
55
0 = Telco Line (no Radio)
1 = LRR/IP(Digital Communication only) and
Telco Line
3 = LRR/IP (Digital Communication only) (no
Telco Line)
5 = LRR/IP (Digital Communication with AAV)
(no Telco Line)
7 = LRR/IP (Digital Communication with AAV)
and Telco Line
AAV
Enabled?
Y/N
0 = Telco Line only (no radio) (see Note 1)
Y/N
1 = LRR/IP (Digital Communication only) and Telco Line (see Note 1)
Y/N
1 = LRR/IP (Digital Communication only) and Telco Line (see Note 1)
Y
7 = LRR/IP (Digital Communication w/AAV) and Telco Line (see Notes 2 & 3)
Y/N
1 = LRR/IP (Digital Communication only) and Telco Line (see Note 1)
N
3 = LRR/IP (Digital Communication only) (no Telco Line) (see Notes 4 & 5)
Y
5 = LRR/IP (Digital Communication w/AAV) (no Telco Line) (see Notes 4, 5, 6)
This option is used to enable/disable Central Station
reporting via the LRR/IP Communications Device (See
Field *77). Upload/ download via the Internet IP module
is not affected by this entry.
The option specifies the channel that the control will use
when sending reports to the Central Station (Follow Me
phone, and Pager). Select some or all channels as required.
IMPORTANT NOTE
Make sure that selected channels are physically available and
functional.
Note: Zone 103 can not be bypassed.
- 3 -
*55 Communication Reporting Channel
Advertisement
