Makita LH1040 Technical Information page 9

R
epair
< 8 > Disassembling motor section
1. Remove carbon brush. See FIg.6-1.
And then, remove table from blade case section as illustrated in Fig.2-1 and Fig.2-2.
2. Remove lever 54 and support plate. See Fig.6-2.
3. After removing four M6x60 pan head screws, motor section can be separated from blade case. See Fig.6-3.
<Note>
Compression spring 9 for shaft lock falls off easily from the machine, when separating motor section
from blade case. Be careful, not to lose this spring.
Carbon brush
Brush holder cap
< 9 > Assembling motor section
1. Putting shaft lock into the notch of motor housing, mount armature to motor housing. See Fig.7-1.
2. While pushing shaft lock to the direction designated with black arrow, mount the motor section
to blade case in order to avoide piching of shaft lock between motor housing and blade case. See Fig.7-2.
3. Take the reverse step of disassembling after the above process.
Notch for shaft lock slide
Armature
Shaft lock
Compression spring 9
Fig.6-1
Brush
holder cap
Carbon brush
Shaft lock
Fig.7-1
Fig.6-2
Support plate
Fig.6-3
Pan head
screw M6x60
Compression spring 9
Fig.7-2
Shaft lock
P 9 / 20
Lver 54
Pan head screw M6x60