Makita LH1040 Technical Information page 11

R
epair
<11> Assembling safety block mechanism
4. Adjust the position of lock lever so that the distance between lock lever and safety cover is approx. 1mm.
See Fig.9-4. And then, finally tighten lock lever with 2 Mx10 pan head screws.
<12> Removing turn base
1. Remove grip 32. From the bottom side of base, unscrew pan head screw M5x12. Now knock spring can be removed.
See Fig.10-1.
2. After removing guide fence, lever up kerf board with screwdriver to remove them. See Fig.10-2.
3. Remove hex lock nut M8x13 and flat washer 8. Now turn base can be removed from base. See Fig.10-3.
Turn base
Fig.9-4
Safety cover
Fig.10-1
Grip 32
Knock spring
Pan head screw M5x12
Lock lever
Approx. 1mm
Guide fence
Hex bolt M8x30
Fig.10-2
Hex bolt M8x30
Kerf board
Screwdriver
P 11 / 20