Makita LH1040 Technical Information page 19

W
iring diagram
Under clamp plate
Before securing clamp plate,
put the lead wires
between rib A and B.
When line filter is used, pass the following
lead wires through line filter.
* Field lead wire
(orange)
* Soft start lead wire
(Purple)
In switch box
Be careful, not to pinch the lead wires of light circuit
between rib B and relay, when fluorescent job light is installed.
When putting lead wires onto relay,
do not put them on this area.
Switch button
Clamp plate
Rib A
Rib B
Line filter
Rib B
Rib A
Put the lead wires, connected to relay
through punched hole, between boss
and rib A.
Put line filter in the space illustrated
above. (exclusively for low voltage
in Great Britain)
Put the insulated connectors into
the space between relay and inner wall,
push into the punched hole.
Relay
Boss
P 19 /20
Field lead wire
(orange)
Soft start lead wire
(Purple)
Field lead wire
(orange)
Soft start lead wire
(Purple)
or
Hole for
pipe 9-126
Inner wall
Punched hole
for lead wires
Noise suppressor
Put noise suppressor
into the space between
relay and inner wall,
or
push it into the punched
hole, when it is used.