Advertisement
2. Mark the location for the magnet on
the
door,
directly
transmitter location.
Caution: Before drilling any holes,
make sure that successful Go/No Go
transmission/reception tests have been
conducted (see previous section).
3. Drill holes at the locations marked for
the transmitter (7/8" diameter, at least
5" deep) and magnet (1/2" diameter, at
least 1-3/4" deep).
4. Insert the transmitter and magnet
cases into their respective holes, so
that their ends are flush with the
surface.
• DO NOT hammer in place with hard
blows. If necessary, tap gently with a
rubber mallet or wood block.
• The transmitter case may be secured
by two screws via the holes in its
mounting flanges, or the flanges can
be snapped off by scoring around
them first with a sharp knife.
• If necessary, either case may be
secured with a suitable adhesive.
A closure plug is supplied to cover an
empty hole if the transmitter is ever
relocated.
SPECIFICATIONS
Dimensions (Approximate) Transmitter: 13/16" (21mm) Diameter x 4-7/8" (124mm) Long
Battery: 3V Lithium. Replace battery only with:
Panasonic CR123A, Duracell DL123A, Sanyo CR123A, Varta CR123A, or Ademco 466.
Regular maintenance and inspection (at least annually) by the installer and frequent testing by the user are vital to
continuous satisfactory operation of any alarm system.
The installer should assume the responsibility of developing and offering a regular maintenance program to the
user, as well as acquainting the user with the proper operation and limitations of the alarm system and its
component parts. Recommendations must be included for a specific program of frequent testing (at least weekly)
to insure the system's operation at all times.
REFER TO THE INSTALLATION INSTRUCTIONS FOR THE RECEIVER/CONTROL WITH WHICH THIS
DEVICE IS USED, FOR WARRANTY IFFORMATION AND FOR DETAILS REGARDING LIMITATIONS OF THE
ENTIRE ALARM SYSTEM.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference (2) This device must accept any
interference received, including interference that may cause undesired operation.
ÊN7022V3GŠ
N7022V3 4/05 Rev. A
BATTERY INSTALLATION OR
opposite
the
REPLACEMENT
1. Remove the transmitter's end cap by
inserting the flat blade of a small
screwdriver in the cap's slot and turning
slightly counterclockwise.
2. Slide
assembly out of its case, taking care
not to bend the antenna during this step
or later.
3. Remove the old battery, if replacing it.
4. Observe correct polarity and insert
the fresh battery into the battery holder
(+ and – polarity indications are inside).
See diagram.
5. Slide the PC board assembly back
into its case, battery end first (the reed
switch end must be toward the cap).
6. Replace the end cap. Line up the
projections
openings at the edge of the case. Press
the cap gently against the PC board
and turn the cap (via its slot) slightly
clockwise, thereby locking it in place.
BATTERY CAUTION: Risk of fire, explosion,
and burns. Do not recharge, disassemble,
heat above 212ºF (100ºC) or incinerate.
Dispose of used batteries promptly. Keep
away from children.
Magnet: 1/2" (13mm) Diameter x 1-3/4" (45mm) Long
TO THE INSTALLER
FCC
ID:
CFS8DL5818-1
CANADA: 573F-58181
the
transmitter
on
the
cap
165 Eileen Way, Syosset, New York 11791
Copyright © 2004 Honeywell International Inc.
www.honeywell.com/security
PC
board
with
the
Advertisement
