Honeywell ADEMCO 5811 Installation Instructions

EXHIBIT 7
SEE NEXT PAGE FOR
FCC / IC STATEMENTS

Installation Instructions

Model 5811 is a single zone Door/Window
Transmitter, compatible with alarm systems
that support 5800 series wireless devices.
5811 has a unique serial number permanently
assigned during manufacture, which must be
entered into the control panel
installation. Refer to the panel's installation
instructions for programming details.
NOTE: During programming of the control
unit, 5811 transmitters should be treated as
"RF" (i.e. supervised RF) Type.
MOUNTING
Choose a mounting location for 5811 where
the device is stationary and the magnet is
mounted to the moving part of the door or
window. To verify adequate signal strength
conduct Go/No Go tests (see control's
instructions) on 5811 before
permanently.
1. Install Battery by inserting one edge
under one of the two plastic battery
retainer clips, then pressing down firmly
to snap it beneath both clips; see
diagram.
BATTERY
(+ SIDE UP)
REED
SWITCH
MAGNET
ALIGNMENT
MARKS
A
INSERT BATTERY
EDGE UNDER ONE CLIP
B PRESS DOWN FIRMLY TO
SNAP BATTERY UNDER
BOTH CLIPS
2. Mount 5811 using double-faced tape
(supplied) by affixing it to the back of the
unit and mounting the unit in place. Use
screws (optional) if desired; see diagram.
Mount the magnet (supplied) near the
alignment marks on the case (see
Diagram).
One Zone Door/Window Transmitter
upon
3. Engage the case tabs (see diagram), then
mounting
rotate the housing to close. Engage latch
with firm pressure to close and lock.
BATTERY REMOVAL
1. Open housing by inserting a flat blade
screwdriver into latch and twisting gently.
2. Remove old battery cell using a small flat
screwdriver blade, as shown in the
diagram.
SCREWDRIVER
(NO)
BATTERY
RETAINER
CLIPS
SCREWDRIVER
(CORRECT)
CFS8DL58112 / 573F-58112
ADEMCO 5811
LATCH
REED
MAX GAP
3/4"
CASE
TABS
MOUNTING
HOLES
SCREWDRIVER
(NO)
X
X
PLACE TIP OF FLAT SCREW
A
DRIVER BETWEEN EDGE OF
BATTERY AND PLASTIC CASE
AS SHOWN. POSITIONING
SCREWDRIVER AT ANY OTHER
CORNER MAY CAUSE DAMAGE
TO DEVICE.
B CAREFULLY PRY UP WHILE
TWISTING TO REMOVE
BATTERY.